Effects of Anisotropic Mechanical Behavior on Nominal Moment Capability of 3D Printed Concrete Beam with Reinforcement (2024-10)¶

In this study, 3D-printed reinforced concrete beams were tested for flexural performance and compared with the analytical model based on the material test results. Two cementitious mixes (PSU and GCT) were designed for concrete printing and were mechanically tested and compared. Anisotropies in the compressive strength and modulus of elasticity of printed concrete were observed, applied to the analytical prediction of flexural bending behavior, and validated by actual test results. Significant differences between analytical predictions and experimental tests of the bending behaviors of the printed concrete beams were observed. Furthermore, higher compressive strengths and moduli of elasticity were observed when the loading direction was perpendicular to the printed layers or with the PSU mix. The effect of anisotropic mechanical properties on a reinforced beam was compared to the flexural bending tests for both mixes. The analytical model based on the material test results was compared to the flexural bending test results. The significant errors in the prediction of printed concrete’s structural performance, from 10% to 50%, suggest that factors other than reduced compressive strengths may influence the structural behaviors of printed concrete beams.